vtec changeover

We may earn a small commission from affiliate links and paid advertisements. Terms

romeirome1

Junior Member
Is it better to have vtec kick in @ a lower rpm or a higher rpm. or does depend on how the motor is built?
 
Originally posted by romeirome1@Dec 30 2002, 08:26 PM
on how the motor is built?

This one.

To decide when you want VTEC to kick in, dyno the car with VTEC set really high, then dyno it with the VTEC point set really low. Set the VTEC crossover where the two torque curves cross for the smoothest transition.
 
What are you driving? Accord f22 v-tec kicks in at 2200 rpm for example and works in a completely different way than say a b16. usually factory is best because without forced induction the car is not moving enough air to use the big cam lobes well until higher rpm's. Of course frankensteins are a different breed since they use bottom ends that never had v-tec. Then it's definately a dyno job.
 
yeah normally it's stock... and higher with after market n/a cams.... that's what i'd do. but if you have access to a dyno do exactly what Calesta said.
 
also if your car is basically stock or has only bolt ons...then a vtec controller was a waste of money
 
Back
Top