Wideband O2

We may earn a small commission from affiliate links and paid advertisements. Terms

Cashizslick

!i!i!i!i!i!i!i!i!i!i!i!
so what does a wideband O2 sensor do and how is it usefull for tuning your motor ?

. . Sorry for the dumb question, and yes i searched - cash
 
most hondas, with the exception of the 5-wire VX and HX, run a Narrow band o2 sensor, either heated (4-wire) or not heated (1 and 2 wire).

Most wideband meters have a 0-5 volt output proportional to air fuel ratio. Noarrow band units, like the stock o2, run close to 1 full volt for almost all ari fuel ratios that a car could possible run "well" under. That output is fed back into the gauge or tuning unit and can be converted into a precise air fuel ratio. The stock O2 sensor is very inaccurate for anything other than 14.7:1 airfuel ratio.

techfjowbo2.gif


as you can see, lean or rich, its still throwing back just under 1 volt. it's near meaningless.
 
so, thats why we go buy a nice one like AEM's wideband o2?
 
yup, cuz it has a meaningful voltage to return, 0-5 volts which directly corresponds with an a/f ratio (depends on the actual wideband. some may start at one and end at 4, and be less accurate for "steps" between)
 
is this decent?:
http://cgi.ebay.com/ebaymotors/ws/eBayISAP...item=2466652634
it looks like that uses the honda 5-wire wideband sensor.

it does... here's the manufacturers site.... http://www.techedge.com.au/vehicle/wbo2/1v5/built.htm in this case, why couldnt you just use this sensor and get a voltage reading and use the formula AFR = 9 + (2 * Vlin) to get your a/f ratio.

some more helpful links... http://www.techedge.com.au/vehicle/wbo2/wblambda.htm
 
Back
Top