Recent content by crx666

hey thanks for all the help got it running great but now NO VTEC???????? when i unplug the vtec soleniod and pressure switch both codes flash..So i think i got it hook up right .and when im driveing i thin i can feel the vtec just a tiny bit but i might be just dreaming or is that possable low...

would a vacum hose in the wrong spot make the code 5? im pritty sure i got the all right.there is one spot on the front of the intake manifold my spare B16a doesnt have it...and i cant find any diagrhams with it either ..And another thing how come after 10sec the code shows up its seems to run...

hey i got a 91 dx hatch obdo B16a pr3 ecu..so i start the car idels bad and after about 10sec the ecu shows code 5 (map sensor) but after it throughs the code it idels fine..so i put a test light on and the yellow/red wire and only lit very dim on the test light and the other 2 wire for the map...

hey i got a 91 civic dx hatch with a B16A and a PR3 ecu just did the swap and the ECU is Flashing 5 time and i couldnt find anthing with a code 5 oh and the cars idel is jumping a little bit..could someone please help me out?...thanks

hey i got a 91 dx hatch with a obd0 b16a and a pr3 ecu..my questions is on the VSS there the cable and 2 open steel hoses and what do i do with the 2 hoses?can i leave them open?

hey i got a 91 dx hatch obd0 B16a and a PR3 ecu . Do i need to run the knock sensor with a PR3 ?just cause the plastic part of the plug on the knock sensor broke off ,and i heard of some ecu's r able to bypass it. Or should i replace the knock sensor and run the wire? I tryed searching for it...

hey thanks for the help efhondakid

hey i got a 91 civic dx hatch..with a obd0 B16A and on the ECU harness and plug A where the vtec wire goes theres a yellow wire and i cant find whats its for on a SI its a empty spot and i think i just add the vtec wire ..but what do u do with the yellow wire for a dx ?and what is it for?? do i...

hey i got a 1st gen B16a obd0 its in a 91 civic DX and as we were hooking up the knock sensor the whole plastic part of the plug broke off...but we still started the car up and seemed to run fine and its not throughing any codes. So im just wondering is it safe to run the car like that? and...

Yeah b16 is a bit better if your just sticken with that. but if your going Turbo . then id go ZC like if u have a good zc not many ks and boost it u can get 180 hp safe and if that not good enough crank it to 10 psi and spank any b16 u want.

Hi i have a zc ill sell runs good. burns no oil its sitting in my room all nice and clean ready to go with trans even axels if you want .I bought it for my crx and i have a turbo kit i bought for it to ill sell u all if u want or just the motor? what ever. around $750 for all or $350 for just...