Recent content by IntegraB18LS

ITR is obd2

Yeah, but the spoon P30 I tried is for a Sir2, that is DOHC so I would think it would work better. even with a big intake manifold I would think I could atleast stay on the side of a completly stock GSR with my GSR powered civic.

also with the spoon p30 ecu I took it to 9000 and it pulled good right to it but vtec still doesnt feel like it is pulling like it should, You have to really listen to tell if it even kicks in, seems to kick in all the time but sometimes you can hardly hear it. I have no codes.

Well like I said I am using a p28 from a 95 ex (d16z6) and the rev limit is 7600 the motor is USDM

I pulled out my b18b1 with p30's the other night and swapped in a b18c1, i put on a new intake manifold (JG), clutch and ACT 12.5lb flywheel. Engine has about 70,000 miles, clean, good compression, starts up very quick and idles beautiful with absolutly no sounds. it is a 99 motor obd2, I used...

like i said i have not put them in yet, I guess ill have enough money in a month or so for a acf, hopfully can find one on ebay..... id rather run rich then hearing my car ping when i press the gas

So if i cut notches in the screews that go into the sensor I can take them out and replace just the sensor? is there any problems aligning it? where can i get just a TPS? would one from a d16z6 work?

shit, thanks man... well i havent put them in yet but my car is running super lean and stutering and stuff so i need to do something but I spent my last 50$ on the injectors untill i can find another job....

Click here I just put in the Centerforce dual friction clutch and ACT flywheel less then 1000 miles ago (800$ just in parts) I have lots and lots of money into this car and it is awsome, very fun car. Lowest I can take is 6000$ look at my cardomain site (above) for info on the car. Kyle

I recently picked up a set of blue top 450cc DSM injectors because I belive i have a clogged one on my turbocharged b18. I purchessed 4 10 ohm 10 watt resistors and i got older civic injector clips. anyways after talking to people I was told my car would not be able to idle and it would run...

I have a 1995 Integra B18b1 engine in my 95 civic and the TP sensor is not giving the correct readings anymore and needs to be replaced. I went to several places and they all told me I need a whole new throttle body!?!? is that true? If so I have a D16z6 TB, will that work? I cant...

so 4 door rear integra seats will fit inplace of 2door civic rear seats? or what modifications are nessisary? Kyle

This may sound stupid but did you (or whoever put the dowel pin in) put them in on the wrong side? just remove them and put them in on the side you need? You sure you have the head gasket on the right way?

I got like a $20 one off ebay and it has taken a beating and has held up great Kyle

vtec isnt suppost to kick in until like around that time 4800-5200 rpm if it went any sooner unless you had enough mods ur engine would just bog down. but yet Vtec is controlled by a wire or 2 on the soliniod and it is opporated by fluid pressure so you need to have enough pressure for it to...