Recent content by razma369600

yea removing the pulleys whould be a start.man that sounds really bad

hi guys just bought every thing for my swap just need to know if i forgot anything. i have a 90 civic hb i just order a obd0 black top zc,dx to zc harness and the pg7 ecu i also got the injector resistor box.Did i forget anything?

just ordered a black top obd0 zc which ecu should i use

hi guys i got a 90 hatch for 150 bucks now when try to get this running i ran into a problem when i turn the key i dont hear anything but when by brother crossed the termanals of the starter all i got was a spining sound it didnt sound like the motor was even trying to turn over is the starter...

hey guys my friend has a 01 lude and he is throwing code 172 for o2 sensor (bank 1)we just replaced this o2 sensor the other week and now its throwing the code again what could be making the o2 sensor go bad? its pretty much a stock motor just a intake on it.any ideas also how do we reset the...

hey guys i was going to put a a6/ z6 mini me in my 90 hatch but i have been looking around at some of the dohc motors, and i have a few questions. first are the dohc zc and b16a 1st gen a drop in swap??and i have found hp ratings for these motors but what about torque?Also what wiring harness...

hey guys i have started my swap and well what do i do about the wiring? I am running a a6 block z6 head and the 90 si tranny some of the problems i see is that the wiring is set up for DPFI and the z6 is well MPFI how do i get around this? Also i have bought a 92-95 si ECU

so how do i mod the d15 harness??

"conversion harness to run the obd1 computer" I am getting the d16z6 wiring harness for free with the head,and I have the car stripped down to nothing.Cant i just use the d16z6 harness or do i have to use the d15 harness?

thanks for the info i am going to use my si tranny but one more questioni have a 92 civic parts car with good coil overs and shocks on it will they fit on the 90 hatch?

Hi guys I just bought a 90 hb for 150 with title frame is good needs new motor. Ok I have a D16a6 block ( 90 civic si) can I buy a z6 head and make a mini me also should I get a d16z6 tranmission?(hydro) or go with 90 si trans which is cable? Cause I have heard the z6's tranny is geared diff for...

the car 92 civic lx the block is a d15b7 the is the 1.6 d16z6 Now you guys say to remove the oil jet? More info on that please Also i should use the si timing belt right ?

hi guys i am bulding a d16 mini me on top of a d15 My question is do i have to swap the D15 water pump with the d16 water pump the d15 has 17 teeth on the gear how many teeth does the d16 have?And also does any one have an ideas on a good rpm active switch

thanks for all the help guys.I got my civic on the road :)

i put in a new head gasket,new intake man gasket and exs. gasket. as far as the pistons rings they looked fine the block looked really good.You see what happen was my cam shaft broke at the end where the cam gear goes on then jump out of time.I put on a new head.But now i have water coming out...