Recent content by sOLLEx

motor: D15B7 out of 93 del Sol s. 100,000 miles stock Includes: long block all internals, alternator, distributor, intake manifold, oil pan, wiring harness and motor mounts except for lower rear, and tranny (needs to be replaced, input shaft is making noise, stock clutch has a little more...

Actually you should be able to see through the tranny with an LSD. If you can't see the whole way through it is not LSD. Also it should be stamped as well. It doesn't sound like you have it. My little 1.5L civic left two black marks on the pavement and i know it had no LSD

if anyone has an b18b1 02 sensor on hand, let me know. I need it for my b20 sol swap. THX

I had the integra ls map sensor plugged in the whole time and i left the d15 one out, i guess i forgot to say that in my post. I only had 2 CEL's, one for the map sensor and one for the oxygen sensor. I have also turned the idle screw many times but that doesn't help much

The Car: 93 del Sol S The Motor: stock 97 B20b (CRV) Tranny: 98 teg type r Bolt-Ons: ACT clutch w/ACT lightened flywheel Intake JDM type R header This was my first swap so i guess it all comes together easier the more you do it but anyhow, the swap went pretty well for this being a new thing...

I actually used a metal punch that tapers down to a small flat end roughly the size of the bitch pin and hammered on that for about 5 minutes. It surprised the hell out of me that it came out so quick.

KY

I believe your still gonna have to buy the new map sensor for the LS tb because your wiring harness is for the ls right?

95 integra LS B18b1: stock bare block - needs pistons and rods stock head w/silver powder coated valve cover wiring harness no alternator no distributor no tranny no ecu no starter no axles 93 del Sol S d15b7 sohc non-vtec: complete stock engine 100,000 miles tranny (needs to be replaced...

Actually, I went to Honda yesterday and the bolts are the same for both the d15 and b16a so they should work with the ITR tranny

I need to know if my d15b7 tranny bolts will work on my ITR tranny and B20 block. The ITR tranny is bare and the damn Acura parts department can't even find the tranny mounting bolts in their computer. I have learned my lesson; you can't rush your first swap especially when the motor is in...

Are the bolts the same for the d15 tranny and the itr tranny? anyone know for sure? thx

I need to know if there are any differences other than the gear ratios in the USDM and JDM type r trannys. The one I have i have is stamped LSD and the serial number includes the S80 code. I don't know if it is from a civic type r or integra type r. I basically need to know which tranny it is...

I am doing a b20b swap into a sol and when i took off the AT bolts and plate, i realized i forgot to get the b series flywheel bolts from a 94 and higher. I searched many junkyards and I finally found a b18a integra and i took those bolts and attached the flywheel with those. Maybe i am just...

I've set aside this weekend to get this shite accomplished with a friend who has done a swap in the past. I hope I have everything together. The list: 97 b20b complete motor and wiring harness with around 100,000 miles 95 b18b intake manny ITR tranny ITR header 2.5 inch carsound cat 2.5 exhaust...