62-1 and B16a

[Johnnylawless]

anybody using this setup or similar, all I keep finding is 1.8l and higher with this turbo
84mm B16a
ge hd sleeves
type r head
H beam rods
turbonetics 62-1 stage 5 turbo

Any HP numbers from anybody running similar setup?

 

[B16RacerN2NR]

Quoted post[/post]]
anybody using this setup or similar, all I keep finding is 1.8l and higher with this turbo
84mm B16a
ge hd sleeves
type r head
H beam rods
turbonetics 62-1 stage 5 turbo

Any HP numbers from anybody running similar setup?

what's up Jim, good to see your motor is coming back together for like the 6th time in 1 year
as for the HP #'s, depends on what compression you are running because if you're too low, you'll have to make up the loss in power with boost, that being said, Jeremy had that turbo on a stock GSR block @ 8lbs on Hondata. If I remember correctly he made like 320whp. Hope this helps.

 

[Johnnylawless]

Hey what up,
Actually for this motor (B16a). It's only the first teardown,hopefully I get the new slugs next week.
and the hone.

 

[posol]

what compression b16? under 9.5:1 that thing is going to be real laggy...

 

[Johnnylawless]

9.8:1

 

[posol]

well, it would def not be my first choice... but if you already got it, go for it.
it will be a killer at the track, but around town its going to suck ass.

i'm guessing 12-ish psi will come on around 6000...

 

[Johnnylawless]

Quoted post[/post]]
well, it would def not be my first choice... but if you already got it, go for it.
it will be a killer at the track, but around town its going to suck ass.

i'm guessing 12-ish psi will come on around 6000...

Right on the money 6K

 

[posol]

ok, so what exaclty is your question?? jsut wanted to see some numbers?

 

[Johnnylawless]

Whp #'s
Dynos of similar setups etc etc