Ok I just finished getting the motor in my car this weekend and double and triple checked to make sure evething is hooked up right. Then I went to fire it and it won't do anything execpt keep cranking and cranking, not even a putter. I replaced Dis. cap, rotor, plugs gaped my plugs at like .050 thousands(thats what NGK recommended). After repeated attempts to start. My dad put his hand over the throttle body so it was covered. And it made my car sputter for like 1 sec. So I thougth it might be vacum leak because the hose I took off Purge Control Solenoid on my sohc motor didn't have a place on my b's intake mani. but I pluged it to see if it would do anything and it had no change. I have no CEL's, and I even tried my P28 I had instead of the P30 it came with but no change. Any advice would help thanks.