1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

dsm 450 or RC 550 injectors

Discussion in 'Forced Induction' started by 93cxhatchbacker, Nov 14, 2008.

  1. 93cxhatchbacker

    93cxhatchbacker turbo noob

    Messages:
    2
    Likes Received:
    0
    Joined:
    Nov 10, 2008
    Location:
    Spokane Wa
    new to the fourm im going to boosting my b16 10-12 pounds wonding if the dsm 450 will work fine or should i op for the RC 550 and spend more going to run a stock block and pistons approx 50,000 miles ebay intercooler kit and cast mainfold with garret t3 turbo off a svo mustang hks bov and tial 38mm waste skunk 2 intake 255 walbro and tuned on crome and head stud should it be fine right what do you guys think of the set up? what kind of power to the wheels advice apreciated......:driver:
     
    Last edited: Nov 14, 2008
  2. austin20110

    austin20110 New Member

    Messages:
    1,272
    Likes Received:
    30
    Joined:
    Sep 24, 2008
    Location:
    Northern Va
    fuck the ebay shit first of all...
    and whp maybe 300 if you get a good tune, but anything over like 250 whp you should get your blocked sleeved just to be careful.
     
  3. 93cxhatchbacker

    93cxhatchbacker turbo noob

    Messages:
    2
    Likes Received:
    0
    Joined:
    Nov 10, 2008
    Location:
    Spokane Wa
  4. Matts96HB

    Matts96HB . Moderator VIP

    Messages:
    6,483
    Likes Received:
    390
    Joined:
    Apr 16, 2006
    Uhh, if you're staying right around 300 whp, 550's would be your best bet. That'd leave you a tiny bit of room to move. 450's would really be pushing it.

    Stock internals (pistons/rods) will withstand 300 whp, but only for so long.

    Throw a set of pistons/rods in there and you're good until about 450 atw, depending on your tune of course.
     
Verification:
Draft saved Draft deleted

Share This Page