OK heres the deal, i just got my ZC motor put into my 88 honda crx SI. everythings wired up the way it should be according to a few internet sites i have looked at( cam angle sensor, etc) now when i try and start the motor, its tryin to turn over, but theres no spark comin out of the distributor. all fuses are fine, all wires are grounded. i checked my ecu which is the 88-89 acura integra ecu, and im throwin a code 15 ( ignition output signal). i went and changed my distribuor out with another zc distributor, and it still wont start. but that could be that bth motors had bad distrbutors from the beginning. before i go spend 150 bucks on a new distributor, i want to know is there anything else i might need to check. any help would be appreciated. if it elps any, i was having prob with starting before in my old S motor, i would drive the car, and when i parked it wouldnt start, there would be no turning over at all, but i had power, eventually it would crank if i let it sit.