1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

modify half shafts to fit b16 swap

Discussion in 'HYBRID -> ED-EF / DA' started by fastcash, Jan 5, 2004.

  1. fastcash

    fastcash Junior Member

    Messages:
    2
    Likes Received:
    0
    Joined:
    Jan 2, 2004
    i was wondering what hasport is talking about modifying half shafts to fit a b16 swap into a 88 crx hf. the hasport sit said that 90 -93 integra shafts would work with modyfing .what type of mods does it take. thanks
     
  2. jlicrx

    jlicrx Senior Member

    Messages:
    1,891
    Likes Received:
    65
    Joined:
    Jun 5, 2003
    Location:
    Colorado Springs
    i believe that Hasport says if your B16 came with a Y1 transmission and intermediate shaft, the 90-93 integra driver's side axle won't fit due to length of intermediate shaft - if you have S1, A1 or J1 transmission and intermediate shaft, the 90-93 integra axles are fine - in any case you need to swap the HF knuckles/hubs with ones from 88-91 Civic/CRX DX or Si - the B16A's with the Y1 transmission have engine serial number that begins with number 5
     
Verification:
Draft saved Draft deleted

Share This Page