I just finished my first swap. It took me a while but I made sure I had all the correct parts. I also did an auto to manual conversion.
Everything is great except for one thing. When I rev or accelerate the car will not go past 4000 rpm's.
I have a new distributor, plugs that are gaped correctly, an OBD 2 JDM B18C, OBD 1 harness and chipped P28. My connections are all secure as well. Here is a list of the things he did to the chip. I am ignorant on ecu's so I'm not sure what some of them are.
VTEC: 4800RPM
Redline: 9000RPM
Launch Control: 4000RPM
Full Throttle Shift: 8500RPM
Shift Light: 8500RPM (Check Engine Lights Up)
02 sensor: DISABLED
Knock Sensor: DISABLED
Speed Limiter: DISABLED
Any ideas? Could the guy that programmed my chip have done something wrong?
Thanks in advance guys.
Everything is great except for one thing. When I rev or accelerate the car will not go past 4000 rpm's.
I have a new distributor, plugs that are gaped correctly, an OBD 2 JDM B18C, OBD 1 harness and chipped P28. My connections are all secure as well. Here is a list of the things he did to the chip. I am ignorant on ecu's so I'm not sure what some of them are.
VTEC: 4800RPM
Redline: 9000RPM
Launch Control: 4000RPM
Full Throttle Shift: 8500RPM
Shift Light: 8500RPM (Check Engine Lights Up)
02 sensor: DISABLED
Knock Sensor: DISABLED
Speed Limiter: DISABLED
Any ideas? Could the guy that programmed my chip have done something wrong?
Thanks in advance guys.