Secondary Runners on the GSR

[MXDesa]

Hey guys, i've tried searching around the forums but with no luck. Im done installing a B18C1 into a 93 Si Hatch. All the wiring is complete except the Secondary runners. Can anyone confirm to which terminal the Wires on the secondaries go to? (Which pin-out number on the ECU do they go to) Thanks

 

[EK_spoon2]

well, if its an obd2a (96-98) gsr then it would be in the "A" connector, pin 26 (IAB) pink/blue wire.
But if its an obd2b (99-00) gsr then it would be in the "B" connector, pin 16 (IAB) not sure of the color probably the same.

 

[MXDesa]

Originally posted by EK_spoon2@Nov 9 2003, 06:02 PM
well, if its an obd2a (96-98) gsr then it would be in the "A" connector, pin 26 (IAB) pink/blue wire.
But if its an obd2b (99-00) gsr then it would be in the "B" connector, pin 16 (IAB) not sure of the color probably the same.

Thanks a lot man, but i thought there were two wires you had to run??

 

[dwnthehatch]

Check out the link in my signature. Of it's an OBD1 B18c1 all you have to do is switch the red wire from A20 to A17. That's it. Here's a video of it in action.

 

[EK_spoon2]

yes there are two wires but the other one...the black one, is the ground wire...it can be hooked up to anyground wire on the engine harness...but of of, they too, have to be "ground" wires...and thats it, your ready ta goo.