jspeccrx91
New Member
they a good or bad idea? who can i get to do it? will they hold up? what's an affordable set of rods if not? i'm working on my n/a b20/vtec. my guess is around 200whp at around 8-8500rpm. mods are:
b20b block 85mm
rs pistons 11.7comp
rods (undecided)
arp rod bolts
fidanza 7.5lb flywheel
ctr crank pulley
exedy stage 1 clucth kit
acl main/rod/thrust race bearings
b16 head with port and polish
dh racing dual valve spring/retainers
(was a little iffy about them but they're working great)
brian crower stage 2 cams
buddy club cam gears
accel 370cc injectors
aebs power products typhoon intake port matched
hondata intake gasket
aebs power products 68mm throttle body port matched
b&m fuel pressure regulator
nology wires and coil
vafc2
custom chipped ecu (modified mugen program burned by my buddy)
password jdm carbon power chamber intake
custom 3" exhaust/no cat with an apexi n1 muffler
b20b block 85mm
rs pistons 11.7comp
rods (undecided)
arp rod bolts
fidanza 7.5lb flywheel
ctr crank pulley
exedy stage 1 clucth kit
acl main/rod/thrust race bearings
b16 head with port and polish
dh racing dual valve spring/retainers
(was a little iffy about them but they're working great)
brian crower stage 2 cams
buddy club cam gears
accel 370cc injectors
aebs power products typhoon intake port matched
hondata intake gasket
aebs power products 68mm throttle body port matched
b&m fuel pressure regulator
nology wires and coil
vafc2
custom chipped ecu (modified mugen program burned by my buddy)
password jdm carbon power chamber intake
custom 3" exhaust/no cat with an apexi n1 muffler