Just wondering if there is a write up on installing the vtec controller on a non-vtec ecu. I pretty much just think you hook the output wires to the vtec solenoid and pressure. Not sure if the inputs are required on a non vtec ecu.
Thanks
Tim
What up! I have a 89 CRX si and i put a 98 D16y8 manual motor in it. everything is good to go, but i have a code 14 on my pg7 ecu. I kept everything all obd0 and everything seems to work fine but that code. I used the service manual and traced the problem back to the ecu. Now before i go...
Okay first off i want to thank everyone that replied to my previous posts on this swap. Thanks to you guys, i finally got the car running code free.
My only question left is, how exactly are you supposed to wire the knock sensor. On the b16 motor the knock sensor had a cap over the knock...
I have a ZC already in my car and the hp is rated at 130. I can get my hands on a D16z6 SOHC vtec engine with tranny and all, but i'm not positive its worth taking out my ZC. The D16z6 is rated at 125hp but its vtec.
Also, is there a way to keep you obd0 stuff instead of converting the...
Hey guy and girls, I only have two codes to get rid of and then the swap is done. The car runs and it drives good (except it pulls to the right for some reason) but i have two codes coming up on the ecu. One is from the Knock Sensor and the other is the TPS.
Now I know how to adjust the...
Okay everything is almost done. I figured out where the Water Temp sensor was. The car runs a lot better now and i only have one code throwing besides the vtec ones(i didnt' up vtec yet) and thats the IAT (intake air temp) code. I looked at a 1st gen b16a manual and it shows the sensor on the...
Okay, i finally got the car running and idling around 1200 rpm. I still have a code 6 and i think possibly another code. But the car runs, so after i put it all back togethor, i noticed that if i tightened up the big nut in the middle of the rotor, that the tires won't spin at all. Is this...
Hey all, I'm a newbie to the board. I have a couple questions. I got a second Gen b16a this I've already dropped in my CRX. Now since the car is a DX i already did the conversion to mpfi. My question is that after all the research I've done on the net I keep on running into problems that...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.