Got a question for all of you...
Just got done doinga head gasket on my h22a
found out the knock sensor was broken but it ran fine before
now it won't run..
anyone know if that would make it not run or should i be looking somewere else for a problem..
Thanks for any help
1995 Honda Accord Ex.
2.2l DOHC Vtech H22a SWAP
97,000miles on Car About 40,000 on engine
5spd w/ Neuspeed Short shift kit
2 Bottle NITROUS EXPRESS KIT w/purge kit (not used)
-Kit mounted were back seat used to be
Reclineable racing seats
Custom Paint job w/Flames with color changing tips...
I am selling a F22b 2.2l SOHC Vtec out of 95 Accord Ex.
Engine has 95,000 miles on it and runs great
Comes with Engine, 5-spd Tranny and ECU.
Needs Wiring Harness and Tp Sensor.
Asking $175.00 plus shipping
Email me any ?'s
Cpratt49@suscom.net
Here is what i have all prices plus actual shipping
Neuspeed Front Strut Bar (painted blue) $30
Neuspeed Sport Lowering Springs $50
Chrome Rear Strut Bar $15
Clear Taillights $20
Email me if you have any ?'s
Cpratt49@suscom.net
I swapped a H22a into my 1995 Accord Ex. and have had nothing but problems
When i start my car the engine pulses from 700-1200 Rpm's when it warms up it stops doing it until you give a little gas then it does it again..
Any ideas what could be the problem
Could it be timing?
I recently did a H22a swap into my 95 Accord
My Question is should i have swapped out fuel pumps?
I ran my car on the dyno and it was running extremly lean
I just got done doing a H22A swpa into my 1995 Accord
The engine runs good but after it warms up and i give it a little gas and let off it drops down to 350-500 RPM's and almost chokes out.
Any idea what would cause this??
Does anyone know if you can tell if an engine came from japan by the engine code..
For Example H22a instead of H22a1 which is on most domestic engines
...b16a instead of b16a1
I swaped the JDM H22a into my 95 Accord Ex. I was running rough but i solved that issue but now the Number 1 Cylinder wont fire. It has compression and is getting spark. I pulled out the injector and swaped it with another cylinder and still only the Number 1 cylinder doesnt fire. Any ideas...
I'm looking to sell my f22b SOHC Vtec out of my 1995 Accord Ex.
The engine has 95000 miles and is in good shape.
Engine come with NGK Plug wires, Chikara Header 4-2-1 5spd tranny shifter cables, shifter, ECU all the sensors(Except TP Sensor) Prelude Axles and intermediate shaft. No...
I did the H22 swap into my 95 Accord Ex and my engine runs but it runs rough. COuld that be because the exhaust is not hooked up and so there is no O2 sensor?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.