pappaj
New Member
I just completed my first swap. I have a few problems but one worries me. My car is lowered about 1.5" and I used the stock integra axles from a 90 teg. I read that these axles are ok to use, and I have also read that you can't use them if your car is lowered. My first test drive besides the guttless low end and the slipping clutch, my car had horrible shake that started at about 20km/hr went away above 110km/hr. When I got home I popped the inner cv boot off and found that the little guide plates on the cv bearings were smashed. The only thing I can think of that would break these is if the axles are bottoming out the inner cv joint. The axles I used I've had lying around along with the motor for about 5 years. I repacked the boots with grease so I know they were not broken before hand. I hope someone has some knowledge on this subject that they could pass along.