i got the wiring finished. not that hard after you figure it out. but now on to axles. i got what i believe to be a 93 integra axles that came with the swap, but the teg axles wont fit into my hubs on my dx. what should i do about this. use the four door civic ex hubs. or the teg hubs. and if so what all do i need. calipers and rotors of course, spindles. and one more question, again not sure of the donor car year, but i believe it to be obd 1. the ecu and the block intake mani. and trans all have a pr4 stamp on them. so is this obd 0 or obd 1 and if it is obd 1 i will need jumper harness for the four wire o2 sensor correct. thanks.