I just got done swapping a d16z6 into a 90 Hatch. It starts up and runs but I have an problem when I press on the gass I don't get any throttle response. I checked the cable and it is connected and tight. What else could it be?
Ok, as soon as it stops raining I'll go check that. Another question the bolt to get to the tranny fluid is stripped is there any other way to add trnny fluid like through the speed sensor hole?
Originally posted by dwn2low@May 18 2004, 05:57 PM Ok, as soon as it stops raining I'll go check that. Another question the bolt to get to the tranny fluid is stripped is there any other way to add trnny fluid like through the speed sensor hole?
sounds like a sensor problem, sounds like one of your sensors doesn't know how much air it's getting and so not requesting enough fuel. are you running the correct ecu?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.