hey everyone
ughhh, im so frustrated its not even funny. i attemped once again to replace my mounts. still no luck. im replacing my shitty mounts with the new HAsoprt ones. so i replace the engine bracket, and remove the front tranny mount, no prob. but then when i try to put on the drivers side mount, it doesnt line up, the engine is about 1/16 or 1/8 or 3/16th of an inch to far to the right.i try pushing the engine over, no luck. so i stat to think that maybe the tranny mount is restricting me, so i remove the old one. the new one was a lil tough getting on, but i got it done. but it still doesnt line up right. im trying to shove it over, but it wont budge. i think it wont move cuase ive got it up on jacks on the ground. but now heres my question, if i have to move the engine over, will it mess with my axles? i know its not moving alot but could this make the driver side axle pop out or push one too hard on the passenger side? and i think i need the rear engine bracket form an 90-93 integra (i know i NEED it, but i dont know if i currently have it or not). im just so frustrated that i cant do this, and now my car is in peices waiting for me to put it back together tomorrow. will i need new axles to put the hasports on? someone please help me out in any way. and if anyone by anychance has the rear engine bracket for a 90-93 integra and wouldnt mind letting it go for free (i have NO money), i would greatly appreciate it. im just hoping that this isnt a bigger task than i thought. [rant/]
ughhh, im so frustrated its not even funny. i attemped once again to replace my mounts. still no luck. im replacing my shitty mounts with the new HAsoprt ones. so i replace the engine bracket, and remove the front tranny mount, no prob. but then when i try to put on the drivers side mount, it doesnt line up, the engine is about 1/16 or 1/8 or 3/16th of an inch to far to the right.i try pushing the engine over, no luck. so i stat to think that maybe the tranny mount is restricting me, so i remove the old one. the new one was a lil tough getting on, but i got it done. but it still doesnt line up right. im trying to shove it over, but it wont budge. i think it wont move cuase ive got it up on jacks on the ground. but now heres my question, if i have to move the engine over, will it mess with my axles? i know its not moving alot but could this make the driver side axle pop out or push one too hard on the passenger side? and i think i need the rear engine bracket form an 90-93 integra (i know i NEED it, but i dont know if i currently have it or not). im just so frustrated that i cant do this, and now my car is in peices waiting for me to put it back together tomorrow. will i need new axles to put the hasports on? someone please help me out in any way. and if anyone by anychance has the rear engine bracket for a 90-93 integra and wouldnt mind letting it go for free (i have NO money), i would greatly appreciate it. im just hoping that this isnt a bigger task than i thought. [rant/]
...if your afraid to damage your axels then take them out...just start with the rear mount and bracket...go do the tranny mount...and then driver side mount...just put it all together and don't tighten anything until all mounts are lined up properly...that's the only i could think of on how to do it because you don't have any money to spend if you break something...better to waste time than money...but time is money so in your case you don't have anything lol j/p 
