C ^crx^ Senior Member Dec 14, 2004 #1 could I set my goal to 300hp with a garret t3/4 with forged rods and pistons, but no sleevs? should i keep the compression ratio around 9,4:1 or could i go higher?
could I set my goal to 300hp with a garret t3/4 with forged rods and pistons, but no sleevs? should i keep the compression ratio around 9,4:1 or could i go higher?
phunky.buddha Mad scientist Moderator VIP Dec 14, 2004 #2 Sure, it's possible- especially if you turn up the boost on forged pistons/rods. Keep your compression ratio in the 9s and you'll be fine.
Sure, it's possible- especially if you turn up the boost on forged pistons/rods. Keep your compression ratio in the 9s and you'll be fine.
92civicb18b1 The Trisexual Dec 14, 2004 #3 it shouldnt be too hard. i would go even lower, 8.8:1, to be on the safe side.
P posol RETIRED Dec 14, 2004 #4 i should save this. i type it 15 times a day. With proper fuel management and tuning, a stock b-series (sans b20b/z) sleeve will hold 300whp. I'd put the b20z/b at about 250 for a safety point.
i should save this. i type it 15 times a day. With proper fuel management and tuning, a stock b-series (sans b20b/z) sleeve will hold 300whp. I'd put the b20z/b at about 250 for a safety point.
9 99SiRidinLow Senior Member Dec 18, 2004 #6 you got that shit! I bet you could almost get it with a stock motor
C ^crx^ Senior Member Dec 19, 2004 #7 well, im trying to set me a low goal and everything above is just a bonus