ok. today (saturday) is the only free time i have available...
i lagged the past two days and forgot to make this thread, so im doing it as my car is on jackstands.
i got shitty matrix coilovers on my ek coupe. i wanted to surprise my g/f when i see her tomorrow and have my shit raised up to stock height. (its a major issue with her, and my car scrapes my downpipe when i enter her driveway) untill i save enough $$ for some good lowering springs, im going to ride stock height for a few.
the matrix coilovers are shot. they sag in the front and im sure this is going to be a 4 hour project. i cant raise them up any higher than they are now due to the fact the spring will not allow the (fuck i forget the term for it...) "circle thingys" that you turn to raise and lower it to go any higher. so im going to have to take my entire strut assembly out of the car and fuck with each one individually.
but can someone tell me how high a stock ek coupe should be in the front, and in the rear? and to measure, i just take a tape measure and measure in the middle to the ground correct?
<<edit>>
2,600 POSTS !!!!!!!!
i lagged the past two days and forgot to make this thread, so im doing it as my car is on jackstands.
i got shitty matrix coilovers on my ek coupe. i wanted to surprise my g/f when i see her tomorrow and have my shit raised up to stock height. (its a major issue with her, and my car scrapes my downpipe when i enter her driveway) untill i save enough $$ for some good lowering springs, im going to ride stock height for a few.
the matrix coilovers are shot. they sag in the front and im sure this is going to be a 4 hour project. i cant raise them up any higher than they are now due to the fact the spring will not allow the (fuck i forget the term for it...) "circle thingys" that you turn to raise and lower it to go any higher. so im going to have to take my entire strut assembly out of the car and fuck with each one individually.
but can someone tell me how high a stock ek coupe should be in the front, and in the rear? and to measure, i just take a tape measure and measure in the middle to the ground correct?
<<edit>>
2,600 POSTS !!!!!!!!