ZC cam angle sensor

[Floydy]

I'm helping my friend put a zc into his crx si. Were almost finished but I'm having trouble figuring out were the two cam angle sensor wires are suppose to go. I know they run to the ecu but I'm not sure which slot they go to. We are using the crx si computer if that makes a difference.

 

[cheese9988]

If you are doing a dpfi to mpfi conversion, you have to run two wires to the computer, at least I did. I forget which pins they are, but a simple wire diagram will tell you. Search on hs or google for that type of conversion, might find it if you search under zc swap.

 

[Dustin_m]

Si's are MPFI

 

[racintweek]

on the SI you should have a blue/yellow wire and a blue/green wire that goes to your dizzy cut those wires and solder them onto the corresponding wires on the sensor on the end of the cam




edit: the blue/green wire is from C1 and the blue/yellow wire is from C2

 

[Floydy]

Ok that makes sense, because my crx was dpfi injection and I had to convert it over to mpfi, but my friends crx is already mpfi so i just need to do what racintweek said to do. thanks