Recent content by psychochicken

Thanks! :mrgreen:

I have a b18A1 flywheel i want to use on a B18B1 with a 5 speed out of a 91 LS will that work? or do i need a b18B1 flywheel, and a 1991 clutch? :blink: Schucks lists the same part number on the flywheel, so i'm safe to assume that i can use the 1991 B18A flywheel onthe B18B... with the 1991...

thanks!!! :worthy:

Summit racing has both 1834cc and 1797cc listed as 1.8L Which would the 96 B18B1 use?

Have a bend rod in the B18B, will the good rods in the B18A work in the B18B?

OK... so after a little more inspection... Here's what were planning to do. 1 - Take the two B18B1 blocks, and make one good one (head on one, block on the other) 2 - Use the B18A1's Dizzy, injectors, harness (DX converted to MPFI) and resistor box Which intake will i need to use? B18A1 or...

OK... A little background, I have a 89 civic DX HB. I purchased a B18A1, w/trans: 91 integra axles, ECU, and motor mounts. I've converted the harnes tp MPFI I found out my B18A1 is toast... (broken motor mount on block) So my good friend gave me 2 B18B1's that appear to be newer... the valve...

Ok, 88 Civic HB, doing a B18A1 Swap. Went to start prepping the motor and folund that someone broke one of the bolt holes on the motor, the one between the timing belt... so the motor is fubar'd... Would of been a good motor too... I found a B18B1... what would i need to do to put the B18B1 in...

I accidentally bought a half shaft from a 90-91 acura integra AUTO will this work on my B18 swap with a MANUAL 5 speed... 89 civic if it matters... Please advise...

So what about an intake... (not the manifold...) Would i get the 90-93 intake or the 88-91 intake?

So i'm putting my B18A1 into my 89 Hatch DX... If i want a header, obviously i'd choose one that would be for a 90-93 acura correct... dah? but will it fit in the engine bay of the civic... I know it's a dumb question... just want to make sure there's not a "special" header that works with...

shoot me an email aaron@nwhybrid.com and I'll give you pop-up cop it'll solve your problems :D

Word to the wise... You need 2 things... a few razor blades... some hot glue or epoxy... Now cut the corners of teh razor blades off... so you have triengles... yuo'll only get 2 pieces off of each razor... get about six or eight... epoxy/glue these to the back of the deck so there in...

thanks, kinda what i though... but wasnt sure...

Hmmm... All these people and no one knows what harness I use??? :blink: <_<