Search results for query: *

My dash lights and gauges flicker or go dead when I turn on the head lights on my 91 CRX.. I recently relocated my battery to behind the passenger seat. When I did that I didn't put a new ground on the transmisison. I had trouble starting the car after that and eventually figured out it was...

Have a 91 CRX with 91 Integra suspension components front/rear. I'm planning for suspension upgrages for next year, would like to... use coil overs to balance/lower the car stiffen the suspension up have adjustable suspension to fine tune the handlingWill I be able to lower the car much using...

Have a 91 CRX with 91 Integra suspension components front/rear. I'm planning for suspension upgrages for next year, would like to... use coil overs to balance/lower the car stiffen the suspension up have adjustable suspension to fine tune the handlingWill I be able to lower the car much using...

Is there a general rule of thumb for selecting a steering wheel size? The smaller the steering wheel the harder it will be to turn.... but how small is too small (for a 91 CRX)?

Well, got it running. Not driveable yet but it was good to hear it fire up. I posted a few times here asking for info/help and got some good responses that helped quite a bit. Thanks, here's a few pics of the install... http://www.42-DontPanic.com

I'm swapping a ZC into 1 91 CRX HF. Got everything bolted in and hooked up but seem to have a distributor and possible timing problem. 1) I removed the distributor and found its very hard to rotate, pretty much need a screwdriver to turn it... I'm guessing this is not only not good but means I...

I apologize if this is already posted, but finding info on the ZC swap without searching on ZC because its only 2 letters is tricky. I'm swapping a ZC DOHC engine, trans, and ecu into a 91 CRX HF. Since I'm using the ZC ecu can I just use the ZC wiring harness as well? It’s complete except...

I'm doing a ZC swap in my 91 CRX HF. Just got the engine, transmission (ZC), and ecu (ZC) yesterday. I know I need to get some axles from a 90-93 Integra but I'm not sure about the knuckles and hubs. I've read that I need the knuckles and hubs from any other CRX or from any Civix other than the...

I'm trying to rebuild a 91 CRX HF and found out the cylinders are going to need bored .030 to make them round again. Any suggestions on finding new pistons for this engine, D15B6?

I'm just starting to build up a 91 CRX HF and have a question about doing it in stages. I would like to start with suspension/tire work first then move into an engine swap (B16), then possible into cosmetic... so basically handling, performance, bling-bling. As I understand it, when I do the...