Search results for query: *

check back in like 3 hrs. everyone. im at work so i wont be able to get to it till im off. thanx

will i see the water moving thru ?

I swapped in a jdm h22a to my 93 si. car runs great for the most part but after running for a while the temp. goes way high. I replaced the h2o pump along with timing and all that before i put the motor in and last night i put in a new thermostat and bled the system, still getting hot...

its not the brakes cuz it rolls about a foot smoothly then something locks up. could be tranny, hopefully not tho, i still have to look a harder and see.

So this is weird. I went to back out of my garage last night and after rolling back about a foot something gets jammed and the car won't roll any furthur. I took my wheels off thinking it was my cv joint but when I turned the rotors they seemed fine and didnt get stuck. I still have to look at...

it was mounted wrong. woops.

way low. what could it be?

My h22a is running now but is giving me 3 codes. MAP sensor and TPS sensor which i'll check later. But the vtec pressure valve (code 22) may be an issure for me. I have no experience workign with vtec stuff so any help on what I should do would be great. I've read I should check my oil level...

got my jdm h22 started last night. i still have to try vtec but its running. thanks everyone for all the help!

This helps me a little but i need to know which wires go in what place in the harness plug, female end. they came out during removal and i may have installed them wrong.

I need to double check my distributor harness plug wire order. i may have miss placed one. so if anyone could get me a good pic of their male end (attached to the dizzy) wires going into the plug so i can see which goes where, it would be very much appreciated.:(

The plug wires came with the motor. i bought a usdm distr. from autozone sat. that uses the external ignition coil and that is not working. the oem distr. was shot. the motor was steam washed and water go into the dizzy, also must of had some cleaning agent cuz it was a little corroded also.

I've put a JDM h22 in my 93 but i can't get a spark. I replaced the whole distributor, cap, rotor, and external ingition coil, and still nothing. heres the rundown: Motor is JDM h22 i bought the rywire vtec harness p13 ecu (usdm, may be an issue..?) distributor is from autozone and i got the...