1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

b16 crx setup

Discussion in 'HYBRID -> ED-EF / DA' started by strangexhaze, Jul 16, 2008.

  1. strangexhaze

    strangexhaze New Member

    Messages:
    1
    Likes Received:
    0
    Joined:
    Jul 4, 2008
    im going to be gettin a complete lsd b16 obd1 swap for my 90 crx. i wanna run some boost on her so im going to get some lower compression pistons and better rods. some arp fasteners, maybe cams..(unsure of cams) for boost ima get a rev hard kit. researching n wat not ive come up with round 320+ hp and round 400 ft/lbs of torque. does this sound right? help me out if you have suggestions please. theyre more than welcome. thanks
     
  2. JdmJc

    JdmJc New Member

    Messages:
    6
    Likes Received:
    0
    Joined:
    Jul 16, 2008
    that sounds like its gunna be a nice setup
    your off too a good start with the low compression pistons
    and rods you might wana stick with your stock cams tho
    with turbo applications stock are usually fine
    as far as your numbers im not sure where you got them from
    but you could get that if you were boosting alot but it would have to be alot!
    your gunna need bigger injectors at least 450cc ,a high flow fuel pump,
    and msd ignition would be even better
     
Verification:
Draft saved Draft deleted

Share This Page