Search results for query: *

I have a set of ZC high compression pistons that I pulled from my z6 block. They are in good condition I bought the pistons new and put my rods in them. These are 75mm pistons that fit in most d16 and d15 engines and can get you much higher compression ratio than stock depending on your...

I have a set of ZC high compression pistons that I pulled from my z6 block. They are in good condition I bought the pistons new and put my rods in them. These are 75mm pistons that fit in most d16 and d15 engines and can get you much higher compression ratio than stock depending on your...

So I bought a zex/comp cams and installed it in my z6. The car ran for about 50 miles then I changed the head( ported polished, valve job). After everything was done, I went to turn the engine over and I heard a loud crackling sound and sure enough the engine wont start. I looked at everything...

Ok so I just finished building my d16 hybrid and this is what I did; Port polish a y8 head and milled the the head, and put in zc pm7 pistons on a z6 block. The car is a 94 hatchback So after putting everything back together, I turned the engine and it starts and iddles for about 30 seconds...

Ok so I just finished building my d16 hybrid and this is what I did; Port polish a y8 head and milled the the head, and put in zc pm7 pistons on a z6 block. The car is a 94 hatchback So after putting everything back together, I turned the engine and it starts and iddles for about 30 seconds...

I have a 1994 civic dx with a d16z6 from the si and am running the p28 ecu. the fuse for my ECU blew, I changed it, the car starts, but was I let of the clutch to drive it, it blows again. Now I've looked for any sign of a short but just cant find any. I'm assuming then that the ECU is gone...

I have a couple of questions. First I know that there is a lot of material on lsvtc on this board but bear with me. I wanted to know where to order that kit that is used to couple the b16 head with the ls block and how much it cost. In putting them together, I know that its best to use arp...

I'm new on this site so forgive me if this question has been asked previously. I'm trying to take apart a b16a that I just putchased and I was wondering if there is a how to on this forum if not, can someone point me to the right direction. Thank you.