B16A2 engine into a 1997 EK9

We may earn a small commission from affiliate links and paid advertisements. Terms

yellowevo2005

New Member
OK I have the engine, tranny,wirng harness, all motor mounts,shift linkage,ECU
the engine was on a 2000 honda civic Si
what else do I need? I'm trying to do it in the next 2 weeks so I need to make sure I have everything on hands :confused:
 
well I did swap the engine before I had a D16y7 now it has a D16Y8 with a P28 but now I want to throw the B16A2
question is the wiring from my D16Y8 and the Si ECUdon't match .
 
I have a P28 ECU that has been chipped but I would need a tune for it and don't want to have the same headacke that I had before when I chipped it for the D16 build engine that it has right now.
I went thru 2 tuners neither one did a good job that's my concern
i want to make it to pass inspection so it can bee OBDII :confused:
 
swap almost done

:confused:OK have the engine installed and ready to get it running as soon as I get my OBD2A to OBD2B jumper harness from rywire since I'm not confortable with tunners around where I live since i got screwed already.
as well Im running the engine bone stock for now.
my questions is where can I find the second O2 sensor the one that goes after the cat I have a few O2 sensors sitting aorund but can't find the connector any help will be aprecciated
 
Back
Top