Thanks in advance for any help I get. I'm in the middle of swapping a B18C1 into a 95 EX coupe. The Civic was automatic and my finace wants to keep it that way. We have the auto tranny. I'm not sure what car it came from, (think it might be LS) as all parts are from different cars, making things much more complicated. To top it off, I believe we were sent a manual harness, or from a pre-94 teg, because three connectors for the sensors for the tranny are not even there. Looks like two shaft sensors and a speed sensor. The tranny is mounted and all and just about to be dropped in. My quesiton is can I just run those three sensor wires to the computer, they are two wire each. The computer is labeled as a b18c1 auto computer, but the year is smudged off, looks like 93, but I dont think thats possible. I do know that the label has a p72 code on it. My other question would be what else needs to be run. I looked at the articles here, but I'm confused because I'm not sure where I stand on the OBD type between the engine,tranny,car and computer. Motor is from 96, so I think thats OBD II. BTW all these headaches arose from thinking I was getting a "complete swap" from one car, not pieces from who knows where. At this point I'm expecting lots of tranny or engine codes, or improper shifting, or who knows what, so I'm looking to get this all figured out. Thanks again