drasticdezignz
Member
I am considering pulling the stock engine out of my 88 CRX DX..
I would like to know if swapping in a d16A1, or d16a3 engine is similiar to the ZC engine swap. The D16 was located in the USDM Integra, while the ZC in the JDM. The only difference I have been able to determine is that the ZC's compression ratio is higher than the D16. What I want to know is; is if the D16 will be similar to the ZC installation [motor mounts, wiring, tranny, and ECU]
Thanks...
I would like to know if swapping in a d16A1, or d16a3 engine is similiar to the ZC engine swap. The D16 was located in the USDM Integra, while the ZC in the JDM. The only difference I have been able to determine is that the ZC's compression ratio is higher than the D16. What I want to know is; is if the D16 will be similar to the ZC installation [motor mounts, wiring, tranny, and ECU]
Thanks...