d16y8

[ls/vtechatch91]

k so im doin a n/a d16y8 in a 90 si hatch.... flame if u want lol... anyways had my blocked honed an found out there was some rust pits in it so they bored it .20 over an there some still there.. so i said do it .40 over...am i gonna be safe? should i use a block guard? im gonna use p29 pistons.. so far i have arp rod bolts, head studs, crower stg 1 cam... h22 tb gonna order a stage 2 clutch an lighten flywheel... its converted too obd1 acl bearings an gonna get a cometic head gasket... so my question is... are my walls to thin?....

 

[oyy0]

did they do it already? and no its not good anymore. almost half an inch??
they should know that; the machine shop.

 

[Honda20000]

.040" is not half an inch. .50" is half an inch.

 

[Honda20000]

fourty thousandths of an inch = .040"
five hundred thousandths of an inch = .50"
ls/vtechatch91 just didn't type it right.

 

[oyy0]

i know.
still.... fourty thou is a lot for this motor.