Finally got this swap in and the car will not crank, no clicking from the starter at all. Car has a p28 ecu, rywire obd0 to obd1 conversion harness, d16z6 distributor, a6 intake manifold, fuel injectors. All grounds are on and tight (front of tranny, thermostat, valve cover). Jumpered the conversion harness and I get a code 15 (Ignition Output). When the car is in the crank position I have no 12v power to the small wire on the solenoid and I also have no power to the ignitor inside the distributor. Someone had mentioned that I might have a bad ignition switch so I ordered a new one but have to wait until I get it. I wired up the distributor with my old obd0 plugs making sure to match color for color (with the exception of the two white wires). Does someone have a diagram or can write me one to confirm my distributor is wired correctly? Any other help is appreciated as I need this thing running soon!