TeamUrbanChaos
Certified H22 Super-tech
ok....this topic is for all you HONDA guru's and tech gods...this forum should answer almost all of my question as well as anyones elses questions about h22 swaps in to an accord or any other h22 swap...after 4 months of procrastinating...i finally got myself an h22. now that i have it i wanna know where i should go form here and some other question that pertain to the motor itself....first off.. i have a 92 accord with the stock F22 motor which is ovibously comming out to put the h22 in but all i have is the motor as of now..( no tranny,ecu) my questions about that are :
1) will my stock 5 speed f22 tranny fit on the H22
2) if so are there any mods required for fittiment ??
3) am i able to use my same wire harness off of my accord for the H22? i heard something about adding 5 wires for the VTEC to work?? is this true
4) i also heard theres some kinda trick that i can use my stock f22 ECU and buy an APEXi V-afc and use that as my vtec engagement??
5) if i were to purchase an ECU for the motor...what would be the best to get? a p13, p28, or a p72??
6) the motor have is an OBD1 93-96 h22...does it have a knock out sensor and if it does what ecu makes provisions for the knock sensor. the last thing i want is to run into a problem with the KS??
7) what is an IAB and what does it have to do with your ECU??
8) can i still use my stock axels, motor mounts, and shift linkage??
9) even tho the steering column on the jdm motors is on the right hand side..does this pose a problem during installation??
1) will my stock 5 speed f22 tranny fit on the H22
2) if so are there any mods required for fittiment ??
3) am i able to use my same wire harness off of my accord for the H22? i heard something about adding 5 wires for the VTEC to work?? is this true
4) i also heard theres some kinda trick that i can use my stock f22 ECU and buy an APEXi V-afc and use that as my vtec engagement??
5) if i were to purchase an ECU for the motor...what would be the best to get? a p13, p28, or a p72??
6) the motor have is an OBD1 93-96 h22...does it have a knock out sensor and if it does what ecu makes provisions for the knock sensor. the last thing i want is to run into a problem with the KS??
7) what is an IAB and what does it have to do with your ECU??
8) can i still use my stock axels, motor mounts, and shift linkage??
9) even tho the steering column on the jdm motors is on the right hand side..does this pose a problem during installation??
Last edited: