ok i jus got done pullin my b16 and i took the head off and wanna put it in the machine shop just not too sure wat to get done...I plan on done an N/A crvtec...wat should i get done!?
I would a.) disassemble it [yourself], b.) have a valve job done, c.) have new valve guides installed and finally d.) have the machine shpo check for levelness to ensure hte head isnt warped.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.