1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Piston ring gap

Discussion in 'Engine Building' started by hondavet1218, Aug 3, 2009.

  1. hondavet1218

    hondavet1218 New Member

    Messages:
    7
    Likes Received:
    0
    Joined:
    Apr 24, 2009
    Location:
    Yakima Washington
    wuts going on honda swappers so im finally getting around to work on my own car after doing a h22a swap in my bros eg and a gsr in my cousins coupe so i was wondering if anyone knows hondas specs to gap my ring im building a lsvtec b18a bottom end with pr3 std bore pistons i know some builds require different thresholds im just trying to go the na route nothing to major thanks
     
  2. hondavet1218

    hondavet1218 New Member

    Messages:
    7
    Likes Received:
    0
    Joined:
    Apr 24, 2009
    Location:
    Yakima Washington
    anybody?
     
Verification:
Draft saved Draft deleted

Share This Page