ok im about to give up on my swap im doing it alone and its my first swap im doing a b18b into a 89' CRX HF and im keeping my stock harness and im using a obd-0 integra ecu but now im near the finishing stages and i messed up by putting my motor in without making sure i had everything to bolt it in. to make a long story short i have my motor hanging over my car with little things here and there and i cant find out a couple things. seeing as this is my only source of info on hondas somebody please help me with these couple things
PROBLEMS:
1. how do i put the rear mount in while my motor is still completely plugged into the harness? i unbolted the other 2 mounts but that only gives me so much room. unfortunately not enough.....any help on this????
2. how do i extend the wires for the MAP sensor and for the coolant sensor? i tried soldering and it didnt work and i tried using clips but that didnt work so how was somebody successful on this part of the swap????
3. how do i take off a brake disk when the 2 screws holing it are stripped? the dumass that owned my car before made nice circles where the screwdriver is supposed to go.
4. how do i take off the rear mount? the one that bolts to the chassis not the block.....specifically how do i get the back bolt of the mount off im looking at it and it looks impossible.
5. i need to see how the vaccum lines go on a 90 integra intake mani.
well thats all i can think of now. i just keep hitting these crappy problems and dont know what to do so if anybody can help me before i give up then please do. or if anybody lives near the 707 area and feels nice enough to come help me then there might be some money in it so anybody help me out. thnx -mike
PROBLEMS:
1. how do i put the rear mount in while my motor is still completely plugged into the harness? i unbolted the other 2 mounts but that only gives me so much room. unfortunately not enough.....any help on this????
2. how do i extend the wires for the MAP sensor and for the coolant sensor? i tried soldering and it didnt work and i tried using clips but that didnt work so how was somebody successful on this part of the swap????
3. how do i take off a brake disk when the 2 screws holing it are stripped? the dumass that owned my car before made nice circles where the screwdriver is supposed to go.
4. how do i take off the rear mount? the one that bolts to the chassis not the block.....specifically how do i get the back bolt of the mount off im looking at it and it looks impossible.
5. i need to see how the vaccum lines go on a 90 integra intake mani.
well thats all i can think of now. i just keep hitting these crappy problems and dont know what to do so if anybody can help me before i give up then please do. or if anybody lives near the 707 area and feels nice enough to come help me then there might be some money in it so anybody help me out. thnx -mike