Search results for query: *

i have disconnected my computer a few times with p28 ecu installed in my 92 honda accord wagon w/built h22a and t3/t4 turbo.now my car doesn't boost to 10lbs anymore only 4lbs and my car seems to stay in cold start idling at 2k sometimes bouncing back and forth from 1500-2500rpm.my qustion is...

whats up, i have 92 honda accord w/built h22a w/t3/t4 turbo.the computer is a p28 w/crome pro base map.when i start my car and rpms raise to 2000rpm on tach. when temperature needle raises to operating temp the idle stays at 2000 rpm,when i give it gas rpm goes up and down from 1500 rpm to 2500...

what's up.i have a built turbo h22a in my 92 accord.i have an issue with idle speed in cold start or at least i think i do.when my car first starts up rpm stays around 2000rpm until car warms up.my car when warm runs at 1500rpm.i would like to lower rpm at idle when warm but don't know how.i...

hey whats up fellow tuners.i have 92 honda accord wagon lx with h22a motor and hydraulic tranny.well for some reason with new temperature switch my fan is not coming on at all.we checked temperature switch plug from harness with temperature switch out and got no power signal,just a dead...

here's a wagon with plenty Turbo Honda Accord station wagon of sleeper power!

hello, i just recently started driven my turbo honda accord,at first acceleration was great but after a week the car dramatically lost acceleration and the car does not make boost like it should.when boost comes in the clutch sound and feels like its slipping.when i press in the clutch i can...

yo what up,i am about to have a jun hyper clutch kit and lsd installed on h22a1 accord.i am tryin to figure out if i am being robbed on labor costs.the shop that i spoke to said it would cost $550 but then when they asked what type of engine is in my accord they changed the labor cost to $700,is...

what up,i have a bad o2 sensor in my honda wagon h22a1 t3/t4 turbo,right now my a/f ratio gauge is not pickin up any signal, meter stays on lean and doesn't move.the meter was workin properly, so i believe the o2 sensor is the problem.now spooling of turbo is not the same and car feels like...

what up,my question is can i use a speedometer cable out of a 89 honda accord for my 92 honda accord wagon.when my h22a swap was done the plug from wiring harness for the speed sensor was not available and still is unfinished.my speedometer does not work because of this.the h22a hydraulic...

what up,my t3/t4 rebuilt 8.9:1 h22a engine has 720 cc injectors.the current ecu has a chipped crome pro base map.the current boost is 10lbs.after i get it dynoed i will turn up the boost to 15lbs.what fuel pressure should i run with the 720cc injectors until car goes on the dyno for...

my newly rebuilt h22a ran for a couple of minutes and then oil was found in radiator after drainage of antireeeze.the oil level was checked and 1/4 quart of oil was missing.how can oil be found in radiator but not antifreeze when oil was checked??:confused:

what up,i have a rebuilt h22a,9:1,ported and polished head.the problem is car started up and is running but oil is dissappearing and is mixing with antifreeze in radiator.the engine has very low fuel pressure.what could possibly cause this problem???my h22a has mahle gold series pistons to work...

what up,i am finishing up my turbo honda station wagon and want to wait to install my accel 300+ignition system until i get my car dyno tuned.the car has a chipped p28 w/crome pro basemap for my rebuilt h22a1 w/t3/t4 turbo and 720cc injectors.the fuel system was completely upgraded.-...

what up,i am installing a apex vtec controller.what is the stock vtec avtivation point for my h22a1?:confused:

yeah,i am installing reprogrammed ecu(p28)on my t4 turbo h22a1 accordwagon and need to set my aem adjustable fuel pressure regulator.what should i set it too? 720cc...

the shop where my h22a1 turbowagon is at said to me that the hold up is because the machinist they are affiliated with misplaced my cam towers.i am tryin to check a price on the parts but can't find the parts online at all. do the cam towers go by a different name or did he make these parts up?:o

whats up,i am putting a t4t-61 turbo on a built h22a1 accordwagon this week.i want to know the rpm the turbo starts spooling up?:confused: what is a reliable rpm range for this turbo and actual rpm boosting range of this turbo?

i have a h22a1 accord w/hydraulic tranny rebuilt w/stage 2 clutch,there is also a custom turbo kit w/t-61 turbo(10psi)how much power can the stock accord axles handle?:confused:

when i had the h22a1 swap done,the tranny was swapped out for a hyhraulic tranny.the mechanic at the time used the accord axle for the right side but could not use neither accord or prelude axle(both were a little too long,wheel would wobble).so what he did is use an integra axle.it was better...

the computer isn't installed yet,i wanted to know is it bad or good with secondaries not activated?should i run a rpm activated switch or leave it that way until a professinal tuner can set it up properly?can it be left that way?h22a1 with 8.9:1 compression,stage 3 head,on 11psi.:confused: