Search results for query: *

I have an Ls/vtec that spun a bearing in the 3rd cylinder. I want to rebuild this winter. The head suprizingly is still good, so I just need to replace the bottom end, what setup should I go with? opinions? I was also thinkin about resleeving?

Hey I have to replace my heater core, being the dash is out of the vehicle, I would like to put in an integra dash my buddy has into my ef, do any of them fit. I could just change all the wiring to integra wiring. can't be that difficult just time consuming, well I have put in weeks to this...

Ok VEHICLE 91 dx, the last owner did the dx to zc conversion on hybridgarage. b10 and b12 run to old c1 and c2 so on... injectors totally separate(custom harness)straight from the ecu plug. he ran a obd0'ed B16a2. so had a resistor box. ENGINE 93...

just got the swap started, but throwing a code, 9? chilton says cyp? that is in the dizzy correct? I have two wires ran from the ecu clip, c1 and c2, through the firewall connected to two wires into the dizzy. I have obd0 to obd1 jumper. request knowledge?

I have two wires left to hookup. C1 and C2 on obd0 clips, My info says Crank angle sensor, where located on the motor? B16a motor XSi, ys1 tanny

The vaccum line directly above the intake on the tb is broken. Is this a problem. I tried an ez out, broke inside, it is plugged up really good now. is this going to cause problems?

I got the swap in it turns over, yippy. Used a little starter fluid ran for about 5 seconds, now the obd flashs= two short flashs and pause then four quick ones. I read my chilton and can't fiigure out what the code or codes are, any help?

Hey I want to move my battery to the hatch(trunk). Do I have to run the ground wire back or can I connect the ground wire off the motor(tranny) to the shock tower? and the Neg off the batt to the rear shock tower? Anyone have a better Idea or experience?

the clutch cable is two or three inches short? any remedies or replacment cables that work?

WHat hoses to buy, Radiator and heater core?

what are the two hoses coming out of the speedo cable housing? Can they just be plugged. 93 b16a

I need to get my harness back to stock the last kid who had the car did a number on it. I need stock ecu pinnouts and wire colors. I have extra wires that need to be hooked back up. I also have a obd1 pr3, anyone know the pinnouts, I can't find anything on it some people told me it doesn't...

Anyone know the ecu pinnouts for a obd1 pr3. As far as I can find it doesn't even exsist.(i have one) I need to know the stock pinnouts for a dx ef civic. and the colors of the wires so I can re-wire it back to stock, the kid who had it before did a number on it. Any help?

91 dx droppin obd1 b16a (XSI). I have the engine harness all the way passed the cannon plugs cut off right before the firewall could I just match up the wires to the wires out of the ecu!! or even repin the harness out of the ecu to cannon plugs. It just seems tedious to take all of the nice...

Do I have to modify the b16 engine harness or do I change the plugs on the dx harness to plug this in, I feel really entimidated right now, anyone my my life easier. Where do I start, what is the easiest way(best way). I know rywire has a conversion harness, but I would have to mail them my...